VWD Overlander Series Half-Slider Van Bunk Windows
The VWD Overlander Bunk Windows can be installed on any Van and are a popular option for Camper Vans. Add ventilation to the rear cargo area of your camper's van bunk area with this easy-to-install flat half-sliding window that features a bug screen and measures 36-3/4" x 13-1/8". The window is crafted with a black aluminum frame that encases solar privacy glass; the unique design allows for installation on either side of the Van. The drainage system is on both the top and bottom of the window and comes with plugs to cover the top holes once the configuration is decided.
Bunk Window Outer Frame Dimensions: 36-3/4" x 13-1/8"
Bunk Window Cut-Out Dimensions: 35-7/16" x 11-7/8
Bunk Window Clamp Ring Size: 1/8"
- Manufacture; Van Windows Direct
- Manufacturing Country: China
- Warranty: 1 year
- Part # OVR3511
What's needed to Install it?
No Additional Products Needed
How will I install this window?
To install the VWD-Overlander Bunk Window Series of windows, you will need to create a template. To make a template, you can either use the aluminum framing on the backside of the window or the clamp ring we will have illustrations on using the clamp ring. Be sure to use the edge of the clamp ring that matches the aluminum frame edge of the window (the aluminum frame that goes through the wall).
Make sure that the clamp ring is taped shut, as it has an opening.
You will then trace your template onto the cardboard box sharpie, black marker, etc.. you do not want to have too wide of a marker as you want to try and be as precise as possible.
After you have drawn out the pattern on the cardboard, it is time to cut the pattern from the cardboard.
Once your template is created, clean up any little rough edges, and we are ready to place it on your van. You will want to measure out for placement to ensure you have your template where you want it to be. To hold the template in place, you can put screws through the cardboard to hold it, have a partner hold or use tape. In our photo, we used tape. Be sure to tape the template in place on the straight areas so those are easy to draw in your line later.
Draw your template onto the wall of the van.
Once you have drawn your pattern onto the wall of the van and are happy with the placement, you are ready to cut. Reciprocating saw, skill saw, disc, nibbler, shears, etc...
Once your hole is made, dry fit the window to make sure the window fits into the hole no adjustments or extra trimming are needed. If you are good, you can add a clear coat or paint to the cut edge it's not necessary, just a precaution.
Now time to install the window. Before putting the window on the van, it's best to go through and make a small pilot hole in all the locations around the trim ring that way, you do not round the heads of the screws when tightening the window.
Put the Window in place from the outside of the Van, allowing the aluminum mounting frame to extend through a hole in the wall. Place the clamp ring from inside most vans will have the split on the bottom. With one person holding the window in place on the outside, the other can start to screw from the inside generally; start with the two at the split in the trim ring to have that lined up then top and around you do not want to fully tighten once all screws are in place, you can then go back around and tighten them be sure to tighten evenly around for proper seal.
Standard Shipping times 1-2 Week Lead Time , with a 1-5 Day Travel Time. (Subject to change due to supply chain issues)